收藏本站
LTC3220/LTC3220-1
OPERATION
If the LED forward voltage is 3.8V and the current sources
require 100mV, the advantage voltage for 1.5x mode is
3.1V ? 1.5 – 3.8V – 0.1V or 750mV. Notice that if the input
voltage is raised to 3.2V, the advantage voltage jumps to
900mV, a 20% improvement in available strength.
From Figure 1, for 1.5x mode the available current is
given by:
Universal Current Sources (ULED1 to ULED18)
There are eighteen universal 20mA current sources. Each
current source has a 6-bit linear DAC for current control.
The output current range is 0mA to 20mA in 64 steps.
Each current source is disabled when an all zero data word
is written. The supply current for that source is reduced to
zero. Unused outputs should be connected to GND.
I OUT =
I OUT =
1.5V IN ?V CPO
R OL
For 2x mode, the available current is given by:
2V IN ? V CPO
R OL
(1)
(2)
GPO Mode
ULED1 to ULED18 can be used as general purpose outputs
(GPO). Current sources in the GPO mode can be used as
I 2 C controlled open-drain drivers. A ULED output can be
selected to operate in GPO mode by programming both
Bit 6 and Bit 7 of its data register (REG1 to REG18) to a
Notice that the advantage voltage in this case is 3.1V ? 2
– 3.8V – 0.1V = 2.3V. R OL is higher in 2x mode but a sig-
ni?cant overall increase in available current is achieved.
Mode Switching
The LTC3220/LTC3220-1 will automatically switch from
1x mode to 1.5x mode and subsequently to 2x mode
whenever a dropout condition is detected at an LED pin.
Dropout occurs when a current source voltage becomes
too low for the programmed current to be supplied. The
mode change will not occur unless dropout exists for ap-
proximately 400μs.
The mode will automatically switch back to 1x whenever
a register is updated via the I 2 C port, when gradation
completes ramping down and after each blink period.
The parts can be forced to operate in 1x, 1.5x or 2x mode
by writing the appropriate bits into REG0. This feature may
be used for operating loads powered by CPO.
Non-programmed current sources do not affect dropout.
logic high. In the GPO mode, dropout detection is dis-
abled and output swings to ground will not cause mode
switching.
The GPOs can be programmed to either act as a switch
(strong pull-down mode) in which the part will only con-
sume approximately 3μA of quiescent current, or they can
be programmed to have a regulated current of up to 20mA
(current limit mode), which would require several hundred
microamps of additional quiescent current.
When a ULED output is used in GPO mode during shut-
down, CPO should not be used as a power source since
the current available from the CPO pin would be limited
by the weak pull-up current source. This weak pull-up is
only meant to keep the output capacitor charged to V IN
during shutdown and is unable to supply large amounts
of current. CPO can, however, be used as a power source
when the part is enabled.
Conversely, when a ULED output is used in GPO strong
pull-down mode, a current limiting resistor should be used
in series with the ULED output so that the current does
not exceed the Absolute Maximum rated current.
32201fc
9
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LTC3230EUD#PBF IC LED DRIVR WHITE BCKLGT 20-QFN
LTC3452EUF#TRPBF IC LED DRIVER PHOTO FLASH 20-QFN
LTC3453EUF#TRPBF IC LED DRIVER PHOTO FLASH 16-QFN
LTC3454EDD#TRPBF IC LED DRIVER PHOTO FLASH 10-DFN
LTC3490EDD#PBF IC LED DRIVER PHOTO FLASH 8-DFN
LTC3783EFE#PBF IC LED DRVR PWM CONTROL 16-TSSOP
LV5026MC-AH IC LED DRIVER 1CH HV 10SOIC
LV5213LP-TE-L-E IC LED DVR 3CH CELL PHONE VCT16
相关代理商/技术参数
LTC3220EPF#TRPBF 功能描述:IC LED DRVR QVGA DISPLAY 28UTQFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3220EPF-1#PBF 功能描述:IC LED DRVR QVGA DISPLAY 28UTQFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3220EPF-1#TRPBF 功能描述:IC LED DRVR QVGA DISPLAY 28UTQFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LTC3220EPF-1-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:360mA Universal 18-Channel LED Driver
LTC3220EPF-1-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:360mA Universal 18-Channel LED Driver
LTC3220EPFPBF 制造商:Linear Technology 功能描述:360mA 18-Channel LED Driver LTC3220EPF
LTC3220EPF-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:360mA Universal 18-Channel LED Driver
LTC3220EPF-TRPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:360mA Universal 18-Channel LED Driver